Pocket door installation in Greenville, SC
Pocket door installation in the Greenville area typically runs $400 to $700 in labor per door. We install the pocket frame kit and the door in non-load-bearing walls, then adjust the track, guides and latch. If the wall is already finished, it has to be opened and patched by a drywall contractor.
Good fit for
- Tight spaces where a swinging door gets in the way
- Bathrooms, closets and pantries
- Walls that are open during a remodel
Options
- Single or double pocket doors
- Soft-close track
- Privacy latch or flush pull
What is included
- Pocket frame kit installation in an open or new wall
- Hanging the door on the track
- Guides, stops and latch adjustment
Not included
- The door and kit
- Opening, patching and painting finished walls
- Load-bearing walls (these need a header and a permit)
What makes the job harder
- Finished walls: must be opened and patched by others
- Wiring or plumbing in the wall
- Load-bearing walls: not something we do
What to send for an estimate
- A straight-on photo of each opening, from floor to ceiling
- A close-up of the existing frame and hinges, if there is a door now
- Width and height of the opening, and the wall thickness
- A photo of the wall on both sides of the opening
- Whether the wall is open or finished
Typical labor: $400–$700 per door. These are planning ranges for labor in the Greenville area in 2026, not a bid. The door itself is not included. Your quote depends on the opening, door type and hardware.
Questions
Can a pocket door go in any wall?
Only in non-load-bearing walls without plumbing or wiring in the way. We check this before quoting.
Where we install pocket door installation
Greenville, SC, Greer, SC, Simpsonville, SC, Easley, SC, Spartanburg, SC, Anderson, SC, Hendersonville, NC, Asheville, NC